He was able to get it running with an Arduino in no time so he decided to take the project a little bit further. What he ended up with is a stepper motor driver which can be controlled over Bluetooth.

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Even first-time users can get a stepper motor moving as commanded in 30 min or less. Commands can be issued from any serial terminal program or from the EZ Stepper Windows program, but the EZHR17EN ...

Seeing this Toshiba motor drive, my first thought was ‘what a neat chip for pairing with an Arduino’ as it combines operation across 1.8 to 7V with up to 4A drive – so that is Li-ion batteries, 5V USB ...

Toshiba Electronics Europe has introduced the TB67S559FTG 50V/3.0A stepper motor driver IC that supports constant current control with built-in current detection.

This Design Idea further develops a previous one integrating a stepper-motor driver in a CPLD (Reference 1). However, this idea integrates not only the driver, but also a simple one-axis stepper-motor ...